Product English Translation

I. Product Overview

II. Product Advantages

1. 1.Absorbs water from leakage points during curing, making it ideal for waterstop with running water.
2. 
   
3. 2.Cures independently without additional materials; curing time is adjustable from 3 seconds to 90 minutes for flexible application.
   
4. 
   
5. 3.The cured colloid features high flexibility, effectively solving structural expansion and contraction problems.
   
6. 
   
7. 4.With viscosity equal to water, it can penetrate all water-permeable cracks. Under grouting pressure, the penetration range can reach 3–5 square meters. It overcomes the defect of high-viscosity traditional grouts that cannot enter micro-cracks, so no dense drilling is required.
   
8. 
   
9. 5.Excellent chemical resistance to most acids and alkalis, and not affected by biological erosion.
   

III. Scope of Application

1. 1.Waterproofing and anti-seepage projects for cracks in:
   household bathrooms, swimming pools, exterior walls, basements, garage roofs, elevator shafts, tunnels, bridges, subways, dams, harbors, and civil defense works.
2. 
   
3. 2.Grouting and repairing dry and wet cracks in concrete structures such as basements, internal and external walls, honeycomb structures, and brick masonry, ensuring full contact bonding.
   

IV. Water-Curing Material Mixing

1. 1.Component A is the main agent: dilute 4kg of Component A with 20kg of clean water.
   Component B is the curing agent: dilute 0.5kg of Component B with 20kg of clean water.
   Stir until completely dissolved.
2. 
   
3. 2.After dissolving, mix Component A and B at a 1:1 ratio and test the curing time.
   The ideal curing time is generally 3–5 minutes.
   
4. 
   
5. 3.For leakage with running water, reduce the amount of clean water appropriately to enhance water absorption at the leak.
   
6. 
   
7. 4.More Component A (with the same water volume) results in higher strength but more brittle colloid.
   More Component B (with the same water volume) results in a shorter curing time.
   

V. Construction Method

1. 1.Drill holes at the leakage area.
2. 
   
3. 2.Select and insert embedded pipes (12mm/10mm/8mm/6mm) according to actual conditions, leaving 20cm outside the structure.
   
4. 
   
5. 3.Seal and fix the embedded pipes with water plugging material.
   
6. 
   
7. 4.After all pipes are installed, start the grouting machine. Connect the mixed AB outlet to the quick connector of the embedded pipe, turn on the manual switch, and start grouting.
   
8. 
   
9. 5.Adjust pressure appropriately according to the structure to ensure the slurry penetrates into the finest cracks.
   If surface leakage occurs during grouting, stop immediately, seal the leak, then resume grouting.
   If an embedded pipe is blocked, drill a new hole and install a PU pipe or replace it.
   

VI. Additional Advantages of the Water-Curing High-Pressure Grouting Machine

1. 
   
2. 1.Highly integrated & finished product
   
3. 2.Simple and convenient operation
4. 3.Reasonable cost
5. 4.Dual suction & dual discharge
6. 5.No cleaning required
7. 6.High grouting speed
8. 7.Time and labor saving