Product Description

1. 1.Hydrophobic MDI-based polyurethane, non-water-absorbent and non-shrinking.
2. 
   
3. 2.Single-component packaging. It reacts with water to form impermeable urethane and will not corrode or damage RC structures and steel bars.
   
4. 
   
5. 3.Excellent toughness; suitable for use in areas in contact with drinking water.
   
6. 
   
7. 4.Suitable for single-component injection equipment.
   

Hardening Characteristics

1. 1.The mixing ratio of SL-668 waterstop with water and temperature have a great influence on curing time and strength.Water volume is directly proportional to curing time.A simple test before use is recommended to achieve optimal performance.
2. 
   
3. 2.The hardened expanded body resists weak acids and weak alkalis, and is compatible with asphalt joint fillers, concrete, etc.
4. 
   
5. 3.When SL-668 PU waterstop is used below groundwater level, excessive water may cause oversaturation and residual water, resulting in poor water sealing.It is recommended to perform 2–3 additional grouting runs after the first foaming to fill voids inside the foam.

Scope of Application

Product Features

1. 1.Reacts and expands immediately upon contact with water; also expands upon contact with moisture in the air.
2. 
   
3. 2.High expansion rate, high hardness, low toughness.
   
4. 
   
5. 3.Strong adhesion to substrates and excellent chemical resistance(resistant to drinking water, seawater, wastewater, diluted acidic and alkaline chemicals).
   
6. 
   
7. 4.No dry shrinkage.
   
8. 
   
9. 5.Non-toxic after full reaction.
   

Construction Method

I. Structural Crack Leakage Treatment

1. 1.Drill holes 5–10 cm to the left or right of the lowest point of the construction joint, at a 45° angle, to a depth of 2/3 of the structural thickness.Drill sequentially from low to high with a hole spacing of 15–30 cm. Install grouting packers at the highest point after drilling.
2. 
   
3. 2.After installing packers, use a high-pressure grouting machine to inject the waterstop from bottom to top until the material overflows from the structural surface, then inject into other packers in sequence.
4. 
   
5. 3.One hour after water stopping, remove the grouting packers.If any material inside the packer is not fully foamed, wait until full curing before filling the holes with sealant.

II. Honeycomb Leakage Treatment

1. 1.Drill holes every 25–30 cm within the honeycomb area, to a depth of 2/3 of the structural thickness.Install and tighten grouting packers, then inject the waterstop with a high-pressure grouting machine.
2. 
   
3. 2.Start injection from the lowest packer.When the honeycomb is filled and hardened by the foamed material and overflows from the surface, continue injecting upward in sequence.The reaction with water fills all fine gaps and completely stops leakage.
4. 
   
5. 3.One hour after water stopping, remove the grouting packers.If any material inside the packer is not fully foamed, wait until full curing before filling the holes with sealant.

Note:

Wear protective equipment (gloves, mask, goggles, etc.) during grouting to avoid direct skin contact.

If splashed onto skin, rinse immediately with plenty of water.

If splashed into eyes, flush with plenty of water and seek medical attention immediately.

Storage Stability

Packaging